EisSound 426A2 Instalační manuál stáhnout pdf (Strana 21)

CC-1122ENG-05

Key Sequence Display Visual

The 426A2 Control Unit is equipped with two alarms that can be individually programmed and can operate in two different modes:

“Music” mode alarm:

Operates only when the Control Unit is off.

At the time and days programmed, the Control Unit switches on with the last music channel played.

The volume is programmable and different for each alarm

Operates whether the Control Unit is off or on

At the time and days programmed, the Control Unit switches on and a specific beep signal is activated. The alarm 1 and alarm 2 beeps are different

and have programmable volumes.

Is equipped with a “delay” function: a short key press of any key returns the Control Unit to its previous state (standby or music) and after 4' the beep

signal is activated again

To cancel the alarm, press any key until a continuous beep sounds: it will return to its previous state (standby or music) and the alarm function ends.

The snooze function may be cancelled at any time by holding down the ON/OFF key for 2 seconds

“Beep” mode alarm:

Access the program menu, select the ON/OFF

status, time and days of the week the function

should operate, as well as the function mode

and volume.

7.10. Alarms

See 6.1.1. Program Menu: alarms

PRG

abc

PRG

abc

They are activated/cleared by using the quick

functions...

The icons indicate if the alarms are

activated.

1 2

1 2 ... 16 17 18 19 20 21 22 23

Komentáře k této Příručce

Žádné komentáře

EisSound 426A2 Instalační manuál Strana 21

Komentáře k této Příručce