
ZONe 01
ZONe 06
4.2.3.C. General Calls And Zone Group Calls
Access the call mode by pressing the key 2”
and select the general/group call mode
Press the key again to active the mode
Use the +,- keys to select the zone number to which you wish to
make the call
Select the group that will
receive the intercom call
Key Sequence Display Visual
GRoup
GR 00
gr 03
calls
m
2’’
m
m
m
m
The volume of the intercom call received is the volume
programmed in sections 4.2.4.D. Receive Intercom Calls Volume.
To adjust the volume, use the +/- keys while the intercom call is
being received (when the intercom call is over, the volume setting
will be stored in memory).
Changing the intercom call receipt volume
Either of the two parties may initiate a conversation at any
time by pressing the key.
Either of the two parties may end the intercom conversation at
any time by pressing the key.
When said key is held , further to canceling the receipt of the call, the control unit will switch to “do not disturb” mode
The maximum duration of an intercom operation (calls + responses) is 3 minutes.
Initiating a conversation
Ending an intercom call operation
It is possible to totally or partially block the call/auto-response process.
See 4.2.3.F.”Do not disturb” function and 4.2.3.H. Intercom Call
Permissions.. When a Control Unit cannot receive intercom calls, the
icon will be lit if the block is permanent or flashing if the “Do not disturb”
function is activated.
2’’
m
An intercom call to a zone group is a call transmitted from a Control Unit and received by the Control Units under the same group (see 4.2.5.B
Control Unit Installation: Group).
A general call is a call to group #0. All the Control Units
belong to group #0 and therefore receive the intercom call unless inercom call reception
is blocked at that time (see 4.2.3.H. Permissions for Intercom Calls Operations).
83
CC-1023ENG-10
Komentáře k této Příručce