EisSound 400 Series Instalační manuál stáhnout pdf (Strana 86)

4.2.3.E. Electronic Baby Monitor

The Baby Monitor is an intercom call operation to an individual identification which is automatically initiated when sound is detected by a Control Unit.

It is designed to monitor someone who cannot access the keypad to transmit a voice message (a child, a disabled person, an older person...). It is

programmed at the transmitting Control Unit (zone to be monitored). There can be more than one Baby Monitor function operating in a system.

The intercom call will

last as long as the

key is held down (the

maximum time

allowable is 1').

Buzz tones are programmable from the interface unit (ref. 43494) itself. It is possible to program the zone number and name without the assistance of

the installer and can be changed with the PC software by using the PC interface (ref. 43491).

For all purposes (permissions, level programming, etc.) communication operations with the entryphone intercom behave the same way as

communication between zones, in this case the entryphone intercom interface being one of the zones.

When someone rings the door bell a specific ring

tone is heard in all the zones of the residence that

have been programmed to receive intercom calls

(the destination of the call from the intercom/

entryphone is programmed right at

the interface 43494).The display

shows the zone number and the

name of the entryphone intercom.

To begin speaking, press and hold it down while speaking to the person at the door. Just as

with communication between control units, pressing the (el símbolo en el teclado) key without

having a zone number slected will direct the call to the last zone with which intercommunication

was held. Evidently in this case it would be the entryphone intercom. If for any reason it has not

been possible to initiate the operation, the information will be shown on the display.

To open the exterior door, hold down the key for 2 seconds. The

conversation will immediately be terminated. If you wish to speak with the person

at the exterior door again you will have 5 seconds during which the conversation

will be reinitiated by pressing the key again.

To end the entryphone intercom communication without opening the door,

press the key (quick press).

Receiving an intercom call from the door

Listening (receiving an intercom call)

Answering (generating an intercom call)

Opening the exterior door

beep!!

Information about the zone

connected to the entryphone intercom

emitiendo avisos

Ending the operation without opening the door

When the key is released the unit goes into

receiving mode, listening to the message from the

person at the exterior door. The conversation is always managed by the

person inside the home by pressing the key to speak and

releasing the key to listen.

CC-1023ENG-10

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 99 100

Komentáře k této Příručce

Žádné komentáře

EisSound 400 Series Instalační manuál Strana 86

Komentáře k této Příručce

Související produkty a manuály pro Bezpečnostní systémy pro řízení přístupu EisSound 400 Series